Voltage:AC110V/220V,50-60HZ

Power:600W-2.8A(220v);5.5A(110V)

Control:DMX-512,outer remote

Spark height:1-6m adjustable

Power:200g(can use 15-25 minutes)

Dmx channels:2ch

Size:256X218X310MM,

Weight:8.8KG 

UNLIMITED TIME TO USE .high-teched plastic

1.1 It is forbidden to open the casing for repair, otherwise it may cause serious accidents.

1.2 The electronic sprayer should be kept dry and not used during rain and snow.

1.3 The top cover of the device must be covered to prevent accidental opening. If the consumables are accidentally ignited, they can only be covered with sand and the air is isolated until it is extinguished. Consumables should be stored in a dry, sealed environment to prevent moisture.

1.4 The minimum safe distance between the person and the inflammable material from the electronic sprayer is 3 meters. The spot that is ejected can only be in the air and cannot touch anything.

1.5 Before the show and after the performance, the clearing function should be used to remove the remaining material from the electronic sprayer. After the performance, observe whether there is no nodulation in the spray port. If it is, it needs to be cleaned up. The nodule will affect the spray effect, and even damage the electronic spray machine, and the residual material in the spray tank of the spray machine. Pour out, the remaining material should be stored in a dry and sealed environment, and then use the clearing function to remove the remaining material of the sprayer line (or directly open the spray machine until no flower sprays out for 30 seconds).

1.6 Single standard electronic spray machine power supply (electronic spray machine pair power cord) can only be connected in series up to 6 units. If there are too many series connections, it will cause damage or fire.

1.7 It is strictly forbidden to block the air inlet and air outlet to avoid affecting heat dissipation.

1.8 It is strictly forbidden to cover the spray port.

1.9 When the machine is working, it should be placed vertically. Do not tilt the spray machine at an angle of not more than 10 degrees to avoid damage to the machine.

1.10 There must be no foreign matter entering the spray port, otherwise the spray machine will be damaged. If any foreign matter enters the spray port accidentally, turn the machine upside down and remove the foreign matter before using it.